|
|
|
||||||||
| RX-7 2nd Gen Specific (1986-92) RX-7 1986-92 Discussion including performance modifications and technical support sections. |
|
|
Thread Tools | Display Modes |
|
|
|
|
||||||||
| RX-7 2nd Gen Specific (1986-92) RX-7 1986-92 Discussion including performance modifications and technical support sections. |
|
|
Thread Tools | Display Modes |
\r\n\r\n\r\n \r\n \r\n \r\n \r\n \r\n 
\r\n \r\n \r\n \r\n \r\n \r\n \r\n \r\n \r\n \r\n \r\n \r\n \r\n \r\n  \r\n 09-24-2008, 08:15 PM\r\n \r\n \r\n | \r\n \r\n \r\n #2\r\n \r\n | \r\n \r\n
| \r\n\r\n \r\n \r\n vex\r\n
\r\n \r\n\r\n \r\n\r\n \r\n \r\n\r\n \r\n \r\n \r\n __________________ \r\n \r\n \r\n\r\n \r\n\r\n \r\n\r\n \r\n He isn\'t a killer. He just wins -' + '- thoroughly.  \r\n \r\n  \r\n\'87 TII \r\n240+ rwhp on my DIY streetport, ~13psi on stock turbo, Racing Beat REVTII exhaust  \r\nrTek 2.1 awaits a tune \r\n \r\n \r\n 360 gamertag: quick Tii\r\n Quote: \r\n
| \r\n|
| \r\n \r\n\r\n\r\n \r\n \r\n \r\n \r\n \r\n | \r\n \r\n \r\n \r\n \r\n \r\n \r\n \r\n \r\n \r\n \r\n \r\n \r\n \r\n \r\n \r\n \r\n \r\n \r\n \r\n | \r\n
|
09-24-2008, 06:49 PM
|
#1 |
|
Rotary Fanatic
|
*&&@#* Oil Injectors
I'm having one hell of a time getting the oil injectors back in tight (the ones on the engine - not the manifold).
The wrenches I have are not narrow enough at the head to slip between the head (red) and the base (yellow) to get a bite on the bolt (green). So, what did you do to get these tight? Did you take a 14 mm and grind down one or more faces, or were you able to find a wrench that is thin enough?
__________________
...shoot a mother-humpin moose, eight days of the week... Last edited by BLKTOPTRVL; 09-24-2008 at 07:11 PM.. |
|
|
|
Threaded Mode