Go Back   Rotary Car Club > Tech Discussion > Show your rotary car build up.
Reload this Page Cerberus Part II!
Home Forum Classifieds Register FAQ Members List Calendar Mark Forums Read

Show your rotary car build up. Show off your Rotary Car build!

 
 
Thread Tools Display Modes
\r\n \r\n\r\n \r\n\r\n \r\n \r\n\r\n \r\n \r\n
\r\n __________________
\r\n 1986 GXL (\'87 4-port NA - Haltech E8, LS2 Coils. Defined Autoworks Headers, Dual 2.5" Exhaust (Dual Superflow, dBX mufflers)
\r\n1991 Coupe (KYB AGX Shocks, Eibach lowering springs, RB exhaust, Stock and Automatic)\r\n
\r\n \r\n \r\n\r\n \r\n\r\n \r\n\r\n \r\n\r\n\r\n \r\n NoDOHC is offline\r\n\r\n\r\n \r\n \r\n \r\n \r\n  \r\n \r\n \r\n \r\n \r\n \r\n \r\n \r\n \r\n Reply With Quote\r\n \r\n \r\n \r\n \r\n \r\n \r\n \r\n \r\n \r\n \r\n \r\n \r\n\r\n\r\n\r\n\r\n\r\n\r\n\r\n\r\n\r\n \r\n \r\n \r\n \r\n\r\n\r\n\r\n\r\n'; pd[137949] = '\r\n\r\n \r\n\r\n
\r\n
\r\n
\r\n\r\n
\r\n \r\n\r\n\r\n\r\n\r\n\r\n \r\n \r\n \r\n \r\n\r\n\r\n \r\n\r\n\r\n \r\n \r\n \r\n\r\n
\r\n \r\n Old\r\n 01-17-2011, 11:01 PM\r\n \r\n \r\n \r\n  \r\n #2\r\n \r\n
\r\n\r\n
\r\n \r\n TitaniumTT\r\n \r\n \r\n\r\n \r\n\r\n \r\n \r\n\r\n \r\n\r\n \r\n\r\n \r\n\r\n
\r\n WE3RX7 is offline\r\n\r\n\r\n \r\n \r\n \r\n \r\n  \r\n \r\n \r\n \r\n \r\n \r\n \r\n Reply With Quote\r\n \r\n \r\n \r\n \r\n \r\n \r\n \r\n \r\n \r\n \r\n \r\n
\r\n\r\n\r\n\r\n\r\n\r\n\r\n\r\n
\r\n \r\n
\r\n
\r\n
\r\n\r\n\r\n\r\n'; pd[141609] = '\r\n\r\n \r\n\r\n
\r\n
\r\n
\r\n\r\n
\r\n \r\n\r\n\r\n\r\n\r\n\r\n \r\n \r\n \r\n \r\n\r\n\r\n \r\n\r\n\r\n \r\n \r\n \r\n\r\n
\r\n \r\n Old\r\n 02-26-2011, 02:00 PM\r\n \r\n \r\n \r\n  \r\n #17\r\n \r\n
\r\n\r\n
\r\n \r\n TitaniumTT\r\n \r\n \r\n\r\n \r\n\r\n \r\n \r\n\r\n \r\n \r\n \r\n \r\n \r\n\r\n \r\n\r\n \r\n\r\n
\r\n vex is offline\r\n\r\n\r\n \r\n \r\n \r\n \r\n  \r\n \r\n \r\n \r\n \r\n \r\n \r\n Reply With Quote\r\n \r\n \r\n \r\n \r\n \r\n \r\n \r\n \r\n \r\n \r\n \r\n
\r\n\r\n\r\n\r\n\r\n\r\n\r\n\r\n
\r\n \r\n
\r\n
\r\n
\r\n\r\n\r\n\r\n'; pd[144105] = '\r\n\r\n \r\n\r\n
\r\n
\r\n
\r\n\r\n
\r\n \r\n\r\n\r\n\r\n\r\n\r\n \r\n \r\n \r\n \r\n\r\n\r\n
\r\n \r\n Old\r\n 03-20-2011, 03:21 PM\r\n \r\n \r\n \r\n  \r\n #32\r\n \r\n
\r\n\r\n
\r\n \r\n NoDOHC\r\n
Prev Previous Post   Next Post Next
Old 02-25-2011, 11:38 PM   #11
TitaniumTT
Test Whore - Admin
 
TitaniumTT's Avatar
 
Join Date: Mar 2008
Location: Right Behind you son
iTrader: (4)
Posts: 4,581
Rep Power: 10
TitaniumTT will become famous soon enough
Default
Those are the latest coils that I tested.... fucking stout coil. Picked up 4rwhp on my car and got rid of the misfire. I don't think they'll pick up much if anything over the Boschs when shes running the 12:1 that she should... but at 10.5:1 where we were, they got rid of the misfire and added 4rwhp uptop.... nothing down low where she was running where she should but yeah... damn fine coils those are. My only complaint about them is that they are BIG

All you need to make those a sub-harness is an 8 or 12 pin deutch. I've got my coils grounded to the mounting plate. I've got an M6 stud with an 8ga wire that daisy chains from the bat, to the power post, to the firewall, to the housings, to that little M6 stud then out to the coils. So when I pull the ignitions, it's only one 8 pin deutsch plug, 4 bolts and the plug wires and the whole thing comes off before you can say DEMS SUCK!
__________________
-The Angry Stig-
DGRR 2009, 2011, 2012 & 2013 - Best FC

DEALS GAP!! WOOHOOOO!!!!!

2015 Audi S4 - Samantha - Zero Brap S4
2004 RX8 - Jocelyn - 196rwhp, 19mpg fuel to noise converter
2000 Jeep Cherokee Sport - Wifey mobile - Now with 2.5" OME lift and 30" BFG AT KO's! So it begins
1998 Jeep Cherokee - 5 spd, 4" lift, 33" BFG's - Rotary Tow Vehicle
1988 'Vert - In progress
1988 FC Coupe - Gretchen -The attention whore BEAST!


I'm a sick individual, what's wrong with you?
I'm pure Evil
I'm still insane, in the best possible way.
I think Brian's idea of romance is using lube.
Your rage caused the meteor strike in Russia. The Antichrist would be proud of his minion.
You win with your thread. Most everything
It's a truck with a steel gate on the back. Just a statement of fact

Motec M820, AIM dash, ported 13B-RE Cosmo, 6-spd trans, 4.3 Torsen, custom twin wg fully divided mani, Custom 4" split into 2x 3" exhaust, Custom HMIC, Custom custom custom custom I like to welder stuff....
No Bolt-ons allowed. Dyno'ed @ Speed1 Tuned by me - 405rwhp on WG.... WM50 cuming soon.
-Angry Motherf*cker Mode ENGAGED-
TitaniumTT is offline   Reply With Quote
 

Bookmarks

« Previous Thread | Top | Next Thread »
Thread Tools
Display Modes
Threaded Mode Threaded Mode

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT -5. The time now is 05:17 AM.

Contact Us - Rotary Car Club - Archive - Top

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Hosted by www.GotPlacement.com
Ad Management by RedTyger