[kansei]

Thanks. My concern was primarily that the resistor value could not be too great (or too weak) to somehow trip the system (I knew about the sensors up front, but had/have no idea how the electrical impulses work such as voltage, amperage, etc. and I'm too lazy to check the electrical manual). I'll just make sure I stay within the 10-330 ohm range.

Just an FYI- the '94/'95 passenger airbag connectors are the same as the driver's side of a '93. My car is technically a '93, but I just installed a sub-1000 mile drivetrain and full wiring from a '94, but kept the '93 dash, hence needing to lose the passenger airbag.

Neal.