Finally done with the grinding on the left side and threw a quick coat of primer on there. I can no longer get the good 3M etching primer here, so I had to make do with Krylon. Which is why there is a color change in my primer.
Oh well. I'm not going to get carried away with paint yet. A good rattle can job will do in the engine bay until I'm done with the engine and all likely mods. I'll then have everything media blasted and use filler (or lead?) to smooth everything out prior to laying on the actual finish coat.
left wheel well 1 by
GySgtFrank, on Flickr
left wheel well 2 by
GySgtFrank, on Flickr
left wheel well 3 by
GySgtFrank, on Flickr
left wheel well 4 by
GySgtFrank, on Flickr
... and a shot of both wheel wells done and in primer. It's amazing how much faster and easier it always is to tear stuff apart rather than putting it back together again.
left and right wheel wells by
GySgtFrank, on Flickr
I still have to do a little cleanup on the bottom of the right side and get it in primer, then I'll be finished with the sheet metal portion. Then back to the lower K-member/upper shock mounts.
*groan* I have to put it all back together again. at least once and probably more, just to check measurements and then take it all back apart again for final fixes to both.
Yes I will get this done this year. At least until I tear something else apart and have it laying in pieces again. I suffer from a little recognized malady known as Brian Treffeisen's Disease, or CQFWI (Can't Quit F***ing With It).
