Quote:
Originally Posted by t_g_farrell
I've read of some racers who bend the rear axle to achieve a fixed camber.
If you want it that badly you should get a 2nd or 3rd gen RX7.
|
Quote:
Originally Posted by orion84gsl
The story goes that you heat the axle tubes where they meet the pumpkin and then bend them to achieve a couple degrees. Kind of one of those might work/might get you killed ideas, but pretty sure it's been done a few times.
|
Quote:
Originally Posted by eprx7
You got it right it has been done, but bearing life is very short.
|
Precisely. I don't recommend this at all. If you have the money, you can build an extremely competent rear suspension setup utilizing the solid rear axle without bending anything.
Considering this is a LeMons car, I say just run it.