Quote:
Originally Posted by Ender
This is the one, you can't tell well because it's blurry, but it's very obvious on both sides that whatever disc they used slipped.
|
Okay, the pics are that bad that I'm not quite sure what you're trying to describe?
The two later ones with the stat gears are fine.
The copper showing on the *seam* of the bearing is okay.
I'm not too sure what is wrong with the bearing on the rotor is?
If anything it looks like it slipped out a little?
If so, you can just press it back in; just make sure the "tab" is aligned correctly.
Else, I don't see any major copper areas showing.
-Ted