|
So here is my list of needed parts so far...
-e-shaft
-front and rear irons
-new rear main bearing and possibly replace all other bearings while I'm at it
-at least one new side seal
-probably some new corner seals
-possibly switch to RA Classic or Super seals
-obviously new coolant seals and gaskets, and possibly oil control rings
-spec housings and possibly get replacements or get them resurfaced
I forgot I have my engine from 3 years ago that I still haven't torn down yet. I'm going to break into that to see if there is anything I can use on this build.
Any suggestions from you guys? What new parts should I get?
|