Vacuum Block Issues/Routing

[My5ABaby]

I have a vacuum block I'm making out of brass fittings. Currently I have my boost gauge (1/8" nylon line), GM MAP sensor (3/16"x12" [needs to be 1/4"]), and FPR (5/32") run off of a single line (5/32") from the manifold. I'm concerned that there's going to be a pressure drop or something from feeding so many things from one 5/32" line.

Is this going to cause any issues?

[88turboii]

i would run the FPR off the nipple on the inside of the LIM. the gauge and sensor should be fine split from one source

[RETed]

It should be fine.

The only one important vacuum line you need to worry about is for the BOV for a turbo engine.
I don't think you need to worry about this in your case.


-Ted

[My5ABaby]

K, good to know. I'm actually currently running without a BOV (very limited) because mine busted... stupid Ebay crap.