weld wheels and stock wheel studs

[sen2two]

Any one here run weld wheels with stock wheel studs? It's a street car so I dont want to go through the trouble of pressing in longer studs into the hubs. Which I heard can be a real pain in the ass. And then i would have to also buy open-ended lug nuts for the wheels i normally run the car on.

I can't see why it would be a problem. But maybe someone here as already done this and has some tips here...

[730RWHP12A]

wont be a problem. i have customers with street cars that have been running this setup for years.

[sen2two]

I figured it would be fine. I just wanted to be sure... Thanks.

[sen2two]

I am guessing 20mm adapters would be enough to clear the brakes and not make the tires hit the fender?

[RETed]

You're asking us without telling us offset, backspace, wheel width, or wheel diameter?
You're wasting our time.


-Ted

[sen2two]

I was referring to the 3.5" wide skinnies up front. They will hit the TII brake calipers if not spaced out or shaved down.

I was told before 15mm works best, but I do not want to cut down the factory bolt (which you have to do with 15mm adapters). I would just use longer studs if i was to do that.