PDA

View Full Version : my nephews Turbo II. 8lbs of boost.

Judge Ito
10-22-2010, 07:23 PM
my nephew Raz and I just spent the last 3 weeks working on his turbo II. here we just finish street tuning his haltech @ 8psi of boost. car pulls strong all through the rpms. we are getting this car ready for Maryland and the import vs domestic event. car will be raced @ 22psi of boost at the event. enjoy the video..

mods are:
series 4 engine
streetport with all new seals clearanced to tight specs.
haltech F10
2 1000cc primaries and 1600cc secondarys
2 msd6al with 2 steps
act clutch kit
bosch in-tank fuel pump
aeromotive fpr
front mount intercooler.

http://www.youtube.com/watch?v=Ez3HvxXyKGM
Judge Ito
10-24-2010, 07:15 PM
2 step installed.. enjoy the video..


http://www.youtube.com/watch?v=KKPpIpPu5X4
89fc3s
10-24-2010, 09:47 PM
that fireball in the second video was so loud that camera couldnt even pick it up lol
Judge Ito
03-26-2011, 06:57 AM
update on my nephews turbo II. yesterday we dynoed the car. made 400rwhp @ 15lbs of boost. tried to dyno at 22psi but the car would not hold more then 15lbs. we will be looking into the boost leak, fix it and go back to the dyno. turbo is an innovative..
diabolical1
03-26-2011, 08:34 AM
sounds like a good result. i shudder to think of what another 7 pounds will yield.
Judge Ito
03-26-2011, 04:51 PM
sounds like a good result. i shudder to think of what another 7 pounds will yield.im looking forward to seeing more results here. so far everything looks promising. we had the intention to video the dyno runs, but all that carbon monoxide had me ready to run out of there. pig rich on the air fuel mixtures..
RotaryXperiment
03-26-2011, 05:08 PM
nice,good job ito!
Judge Ito
03-26-2011, 05:26 PM
nice,good job ito!

thanks alex. this engine also uses the goopy refinish
rx71king
03-26-2011, 11:35 PM
what's the timing on that bad boy....are you running the leading through the cap and rotor.?...sounds on point.........good luck at the event
Judge Ito
03-27-2011, 05:49 AM
what's the timing on that bad boy....are you running the leading through the cap and rotor.?...sounds on point.........good luck at the event

running leading off the distributor cap. mite not go to the event. it's freezing outside..