clutch job question

11-14-2008, 08:20 AM

It is not a hard job to replace a clutch (and a flywheel) on an RX8.

Takes about 5 hours on your back.

Make sure you have your clutch kit, fluid, and a new pilot bearing seal (if u plan to replace the pilot bearing) have everything ready and it shoudl not be that bad of a job for even a beginer to do.

Good luck.

11-14-2008, 08:20 AM	#8
SpooledupRacing Guest Posts: n/a	It is not a hard job to replace a clutch (and a flywheel) on an RX8. Takes about 5 hours on your back. Make sure you have your clutch kit, fluid, and a new pilot bearing seal (if u plan to replace the pilot bearing) have everything ready and it shoudl not be that bad of a job for even a beginer to do. Good luck.