Go Back   Rotary Car Club > Tech Discussion > Show your rotary car build up.

Show your rotary car build up. Show off your Rotary Car build!

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 12-21-2016, 09:22 AM   #18
infernosg
IT'S ALIVE!
 
infernosg's Avatar
 
Join Date: Dec 2009
Location: Richmond, VA
Posts: 811
Rep Power: 17
infernosg is on a distinguished road
Finally got the idle sorted out. It turns out the culprits are the aftermarket (Airtex) points I purchased a while back. Even though the car has only 26,500 miles I figured it'd be a good idea to overhaul the ignition so I replaced the distributor cap, rotor, capacitors, and points along with the spark plugs and wires. Ever since the bouncing idle started I've been slowly swapping the stock parts back in. Go figure the last parts I swap back in, because I've been avoiding resetting the points gap, fixed the issue.

On top of that I started pre-mixing at a ratio a little less than 0.5 oz to 1 gal with this tank of fuel. After that I re-set the ignition timing (with the vacuum advance disonnected this time) and the idle fuel mixture and speed and she's running as smoothly as ever despite temperatures in the mid-30's (Fahrenheit). Hell, once warmed up she's so quiet I can barely tell she's running!
infernosg is offline  
 

Bookmarks


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 01:39 PM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
Hosted by www.GotPlacement.com