|
Rotary Tech - General Rotary Engine related tech section.. Tech section for general Rotary Engine... This includes, building 12As, 13Bs, 20Bs, Renesis, etc... |
Welcome to Rotary Car Club. You are currently viewing our boards as a guest which gives you limited access to view most discussions and access our other features. By joining our free community you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is fast, simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact contact us. |
|
Thread Tools | Display Modes |
06-14-2012, 02:00 AM | #1 |
The Newbie
|
3 window bearings
Can u use the 3 window bearings with the stock stationary gears, or do you have to use the special grooved bearings? Also I'm using a e&j throttle body, so would it just be better to put the grooved gears???
|
06-14-2012, 10:01 AM | #2 |
Rotary Masochist
|
The bearing will "fit" any gear. However, you need the galley machined into the inner circumference of the gear for the multiple windows of the bearing to be effective. The 3rd gen gears have the galley machined in from the factory. You can also have the earlier gears macined. The 3rd gen multi-window bearing has the same 360* oiling as the 3-window race bearing, but its a lot cheaper. You can buy a new Renesis gear with bearing for not much more than the price of the 3rd gen bearing.
__________________
_______________________________________________ One stop Haltech, AEM, Syvecs shopping. Installation and tuning. http://www.lms-efi.com Free support. Drop us an email. chris@lms-efi.com 502-515-7482 Facebook @LMS-EFI |