I am putting my 1988 turbo 2 10th Anniversary Edition up for sale. I have owned the car for 3 years and it has come a long way. Car has no A/C, Power steering, stereo, or speakers. It also has a kill switch in the rear. This car can make 450 at the wheels w/ ease. Car fires up first time every time like a stock car. Anyways on w/ the mod list
ENGINE
-S4 block w/ S5 rear plate.
Motor has 1K on rebuild from cracking S4 rear plate. (Secondaries are port matched)
-Rotary Aviation Super seals
-Atkins Rotary new solid corner seals
-New FD main bearings
-New rotor bearings
-Large street port
-8.5:1 compression rotors
-New oil control rings
-Low mileage S4 rotor housings
-ACT 6 Puck Clutch
-Emissions removed
-550 RC Engineering primary injectors
-1680 secondary injectors
-Greddy Compression tube
-Motec LS1 type coils
-Greddy Type R BOV
-HKS Cast manifold
-Precision 67mm T4 .96 exhaust housing
-Tial 38mm wastegate
-turboblanket
-double alt pully w/ rotor emblem
-Ebay intercooler (Godspeed I believe but cannot remember for sure)
-OMP still hooked up (mechanical)
-Walbro 255 fuel pump
-Areomotive FPR
-Koyo Rad
-Flex-a-lite fan
Engine Management
-Haltech E8 w/ innovate LC-1 (rebadged w/ Haltech name)
Interior
-Yanaka Motorsports racing seats on FC rails
-Autometer Tach, water gauge, and boost guage
-Mazda trix short shifter
-clock and warning cluster are still operational and work perfectly.
Brakes
-new pads 3k ago
-stainless steel brake lines
Exhaust
-3inch straight through w/ a dynamax bullet in place of the cat and a magnaflow muffler on the end. Tubing is 304 stainless except for a 1 foot section where I ran out of stainless and used mild in that section. You can see it in the photos.
The bad.
Currently the car is 3 different colors, 2 shades of white with a grey hood, which is a little beat up. The body has less than 4 dings in it minnus the hood obviously. The panels are perfectly smooth, but the car was painted by 2 different people right before I purchased it. one painted the main body in a white of his choice. The other person painted the fenders, sunroof, mirrors, front bumper, spoiler, rear bumper, and gas cap the correct 10th AE off white. This was all done by the previous owner.
The black wheels in the photos do not come w/ the car. I will include the stock 10th AE wheels, and if it is purchased for my asking price I will put new tires on the stock wheels for the new owner.
I am asking $5500 for the car as it sits w/ the stock wheels. The tune is slightly on the rich side currently with conservative timing. The car runs and drives great but it can make more power. I have a dyno sheet from when I ran it down at Steve Kan's place in May w/ a 3 gear pull on his dyno.
I am planning on painting the car early in August. If I still have the car then the price will go up accordingly to $6500.
You may contact me at (405)317-5095 or
rotaryinspired@yahoo.com. If you have any questions or would like other photos feel free to contact me and I will get more.
Thanks for looking,
Brad
10th AE w/ major mods/ OKC, OK
Linear Mode
