2 questions, clutch bleeding

Phoenix7 · 05-28-2008, 05:35 PM

well, if you can't stop the leak then you need a new line and slave.

As far as the RPM drop. Are you in gear driving or stopped in neutral?

No more 1337 posts for me.

a7xh7 · 05-28-2008, 06:32 PM

neutral sir

Phoenix7 · 05-28-2008, 06:52 PM

you've checked for vaccuum leaks? How many miles on teh motor? Injectors are clean? timing and TPS up to spec?

a7xh7 · 05-28-2008, 10:07 PM

motor is recent rebuild. injectors were cleaned/flow tested but had been sitting for some time after cleaning, i bought them off a club member. timing and tps.. haven't checked them but i am on stock ecu and the same ecu/setup was used without this issue prior to rebuild. vacuum leaks.. pretty sure everything is hooked up right.. is there a reason that vacuum could cause this issue at only a specific rpm? the thought of injectors crossed my mind, but again, why only at this rpm. it would be great if i had more knowledge of the vac system and fuel/timing etc controls that are activated/involved at my problem rpm but im a relative novice

05-28-2008, 06:32 PM	#17
a7xh7 Rotary Fan in Training Join Date: Mar 2008 iTrader: (0) Posts: 88 Rep Power: 0	neutral sir __________________ "sevens_ix"

05-28-2008, 10:07 PM	#19
a7xh7 Rotary Fan in Training Join Date: Mar 2008 iTrader: (0) Posts: 88 Rep Power: 0	motor is recent rebuild. injectors were cleaned/flow tested but had been sitting for some time after cleaning, i bought them off a club member. timing and tps.. haven't checked them but i am on stock ecu and the same ecu/setup was used without this issue prior to rebuild. vacuum leaks.. pretty sure everything is hooked up right.. is there a reason that vacuum could cause this issue at only a specific rpm? the thought of injectors crossed my mind, but again, why only at this rpm. it would be great if i had more knowledge of the vac system and fuel/timing etc controls that are activated/involved at my problem rpm but im a relative novice __________________ "sevens_ix"