Now it's time for Teh Turbo!
Tearing out stock parts:
stock exhaust manifold out of the way. Renesis, weird exhaust ports:
New Garrett GT3071R twin ball bearing Turba!
The turbo in!
Not a whole lot of space:
You can barely see the compressor housing peaking through the manifold and motor mount:
FMIC all mounted up:
Custom aluminum cold air intake:
Had to extend the MAF harness:
Had to radius the downpipe holes for the dp nuts to clear:
Sort of finished, using a temp air filter until I could find one that fit behind the bumper
Installing a Snow Stage 2 Water/Meth kit:
Painted the solenoid and made a bracket to hold it:
Made some custom brackets to hold the tank and painted them as well:
And mounted the controller to the back of the tank and covered it with a piece of aluminum sheet to protect it.
Pump mounted on a custom bracket that mounts where the factory electric air pump goes:
Custom LS2 Yukon GM ignition coil setup:
Chickenwafer's Never Over Turbo 8 Build
Linear Mode
