CDI ignition wiring help.

Prodigy · 06-03-2015, 06:41 PM

Got some more done, all crimped/potted/shrunk. The Y spot of the wire has a bit of a hole that's moisture/debris could get into. So I'll be filling that with some black silicone later.

I'm happy with the result do far, not perfect as I usually hope for, but I know I tried to do a good quality job. Would have been nice to have Y shrink boot, but I'll make it work.

J.

RICE RACING · 06-03-2015, 07:16 PM

I think you have done an EXCELLENT job, feel free to post finished pics up in the CDI COP thread of mine

The set up looks gag factor good! I am surprised more people dont go for this yet????

oh p.s. you will need to trim the mounting bushes flat on the M&W coils, they all vary on them, they sit proud of the nylon casing and push the coils to be non central over the spark plug nipples, only takes a few minutes on a grinder to do, if you look at my pics close you will see I have done it to my own personal coils

06-03-2015, 07:16 PM	#17
RICE RACING Don Mega Join Date: Dec 2008 Location: Utopia iTrader: (0) Posts: 1,688 Rep Power: 17	I think you have done an EXCELLENT job, feel free to post finished pics up in the CDI COP thread of mine The set up looks gag factor good! I am surprised more people dont go for this yet???? oh p.s. you will need to trim the mounting bushes flat on the M&W coils, they all vary on them, they sit proud of the nylon casing and push the coils to be non central over the spark plug nipples, only takes a few minutes on a grinder to do, if you look at my pics close you will see I have done it to my own personal coils __________________ www.riceracing.com.au Worlds best Apex Seals Coil on Plug Water Injection ECU Calibration