Go Back   Rotary Car Club > Tech Discussion > Piston Engine Conversion

Piston Engine Conversion Have you replaced your rotary with a V8 or any other type of piston engine? Tell us about it!


Welcome to Rotary Car Club.

You are currently viewing our boards as a guest which gives you limited access to view most discussions and access our other features. By joining our free community you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is fast, simple and absolutely free so please, join our community today!

If you have any problems with the registration process or your account login, please contact contact us.

Reply
 
Thread Tools Display Modes
Old 06-18-2013, 09:16 AM   #1
Whizbang
Respecognize!
 
Whizbang's Avatar
 
Join Date: Jul 2008
Location: Δx = ħ/2Δp
iTrader: (5)
Posts: 3,190
Rep Power: 20
Whizbang will become famous soon enough
Default Car cooling issues? maybe?

Might be paranoid or it could be the exhaust fumes getting into the car but anyway...

I noticed that when im at low speeds or stopped with the fans on the car sits at about a hair under 180*F to about 185*F. When im driving at speeds over 25mph, it actually starts to get a little warmer.

The commute to work was okay, freeways getting about 195 degrees at maybe 55 ambient temps.

I noticed yesterday during my commute home from work, doing freeways speeds (65-70) the car got rather hot like 230-235*F. Or is that even reallly THAT hot? this was flat ground, no hills. Hills caused a little creep, but not much. Outside temp was 95 degrees. Fans on or off didnt make too much difference. This was the same situation the weekend of the Idaho Rally driving in to the mountains. Not even really "getting on it" the car just got hot going up hills but cooled down once i was flat or going down hill in neutral.

I had no ducting around the radiator AT ALL. Nothing. So im thinking there is less resistance for the air to go around the radiator than through it at higher speeds. So last night I made some ducting from aluminum. Need to support the lower part since it bent down on the freeway (doh!) and the one side was rather complicated so i want to use rubber there instead of Al.

Going to work this morning, its cooler outside (55ish) and the temps where better at about 195. So it could be the bent ducting on the bottom, but not really looking too different. I'll see on the way home.

thermostat is 180*.
miata 1.6 engine
saab 900 turbo radiator and fans
nothning fancy about the coolant
4,78 gears


thoughts?






__________________
For current updates and event coverage check out
Follow on Twitter! @WhizbangRally
Whizbang Rally's Webpage | Facebook
Whizbang is offline   Reply With Quote
Old 06-18-2013, 11:36 AM   #2
t_g_farrell
Waffles - hmmm good
 
t_g_farrell's Avatar
 
Join Date: Aug 2008
Location: Huntersville, NC
iTrader: (0)
Posts: 757
Rep Power: 0
t_g_farrell is on a distinguished road
Default

The radiator offers resistance to the air flow and at higher speeds the air it will try to spill around
and not through the radiator and you will see higher temps.
__________________
1980 GS stockport, Fat Nikki, RB Dual Facetfuel pumps, Holley regulator, RB Street port exhaust, 2GDFIS, MR2 MK I electric fans, 2G strut bar, relayed fans, lights and fuel pump, LEDs

Project Fat Nikki Budget 12A rebuild Video setup < $30.00
t_g_farrell is offline   Reply With Quote
Old 06-18-2013, 02:03 PM   #3
Pete_89T2
Lifetime Rotorhead
 
Pete_89T2's Avatar
 
Join Date: Apr 2010
Location: Elkton, MD
iTrader: (1)
Posts: 874
Rep Power: 15
Pete_89T2 is on a distinguished road
Default

Perhaps the radiator is internally clogged in spots, or has enough bent fins to impede airflow through it? Possibly a defective thermostat? Either would cause less than optimum cooling. You can visually check for bent fins. As for clogs, run your hand over the entire surface area of the rad and see if you feel any spots that are relatively cooler than the rest - that's where the clogs will be.

Ducting the radiator so air flows thru rather than around it should help. If either the radiator, its fan or ducting is deficient, you can expect temps to go up as you drive faster, as the engine is working harder and producing more heat.
Pete_89T2 is offline   Reply With Quote
Old 06-18-2013, 04:59 PM   #4
mattallac
Rotary Fanatic
 
mattallac's Avatar
 
Join Date: Aug 2011
Location: crockett ca.
iTrader: (1)
Posts: 176
Rep Power: 0
mattallac is on a distinguished road
Default

Things I would do are 1 put a new thermostat in the car (180 degree), they are cheap. 2 there is a product for cummins diesel that is made to clean the motor and radiator while you drive , When I find my bottle I will get the name for you 3 drain your coolant and use 85% REd line water wetter and 15% red coolant ( toyota or gm ) the reason for the red is because it controls ph levels for motors that have aluminum parts . Also water pump blades could be rotted off .And if the radiator is clogged get an aluminum champion radiator from e bay , there is no epoxy in the radiator and they are 100% welder . I have one for an rx7 in a glc 12a car and the radiator works great ( I never pass 190) good luck
mattallac is offline   Reply With Quote
Reply

Bookmarks


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 02:46 PM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Hosted by www.GotPlacement.com
Ad Management by RedTyger