Just had the car thoroughly inspected by Ihor and RIch's shop and had the following fixes done:
Rotary engine compression test
Replace engine oil and filter
Install new spark plugs
Replace ignition wires
Remove aftermarket bov and install stock bov
5 Vacuum hose replacement and tie job
2 Replace oil metering lines
1 Replace fuel pulsation damper and associated fuel hoses
5 Re-seal oil pan and install reinforcement brace
3 Replace and relocate fuel filter
1 Replace coolant and flush system
.5 Replace differential gear oil
1 Re-install stock intake, intercooler duct, and battery box
1 Replace front stabilizer end links, bushings, and mounts
Replace power steering hose
1 New OEM Mazda FD Oil Pan
1 Oil pan reinforcement brace 13brew and hardware kit
1 motor mount with steel arm, good condition
Hose Techniques silicone vacuum hose, black
1 Mazda OEM fuel pulsation damper
6 5/16" high pressure fuel injection hose
FD primary fuel injector insulator
1 Mazda OEM Fuel Filter
5 10w30 mineral motor oil, 1qt
1 Oil Filter, Mazda RX-7
2.5 Premium Coolant
1 Mazda oem water hose, from rear iron
1 Mazda oem water hose, behind alternator
1 HOSE/WATER throttle body
1 Mazda oem coolant hose, filler to overflow
1 Filler neck to ast hose, fd
1 ast hose
4 NGK spark plugs
1 Mazda OEM NGK ignition wire set, fd
1 Stainless steel oil metering lines
2 Mazda OEM Oil Injector
3 good condition sequential turbo solenoid
2 FD OEM Mazda Front Sway Bar Bushing
1 FD OEM Mazda Front Sway Bar End Link, Driver Side
1 FD OEM Mazda Front Sway Bar End Link, Passenger Side
1 FD OEM Mazda Sway Bar/Radiator Mount, Driver Side
1 FD OEM Mazda Sway Bar/Radiator Mount, Passenger Side
1 Mazda OEM AST and cap
1 Power steering pump to reservoir suction hose, fd
1 Oil level sender o-ring, fd
1 Oil Filler Neck O-ring, mazda oem
3 Idemitsu 75w90 Synthetic Gear Oil
1 Idler pulley with bearing, fd
And getting it professionally detailed this week.
|
Linear Mode
