My ongoing project car

N.RotaryTech · 12-14-2010, 07:52 AM

I didn't port those ports.
Not yet anyway.

Imo, the lower ports look fine, but the aux ports are uneven, a little shloppy.

I looks like the corner seals might be about 1/3rd supported.

The bridge port motor.
I'm thinking I'm not just going to forget that motor.
I have a plan to sometime, put it back together, reusing the o-rings and other seals, and block off that one coolant passageway, then do an engine swap, maybe for just a few weeks, run it, take it for a mtn run, and get it dynoed, then swap the good motor back in.
Cause I still like that motor.

But for now, Im going with this street port motor.

12-14-2010, 07:52 AM	#1
N.RotaryTech Home-brew Rotary Join Date: Feb 2008 Location: GooseCreek SC Posts: 552 Rep Power: 18	I didn't port those ports. Not yet anyway. Imo, the lower ports look fine, but the aux ports are uneven, a little shloppy. I looks like the corner seals might be about 1/3rd supported. The bridge port motor. I'm thinking I'm not just going to forget that motor. I have a plan to sometime, put it back together, reusing the o-rings and other seals, and block off that one coolant passageway, then do an engine swap, maybe for just a few weeks, run it, take it for a mtn run, and get it dynoed, then swap the good motor back in. Cause I still like that motor. But for now, Im going with this street port motor.