|
|||||||
| Rotary Tech - General Rotary Engine related tech section.. Tech section for general Rotary Engine... This includes, building 12As, 13Bs, 20Bs, Renesis, etc... |
|
|
Thread Tools | Display Modes |
|
|||||||
| Rotary Tech - General Rotary Engine related tech section.. Tech section for general Rotary Engine... This includes, building 12As, 13Bs, 20Bs, Renesis, etc... |
|
|
Thread Tools | Display Modes |
03-19-2009, 04:24 PM
|
#1 |
|
RCC Loves Me Not You
Join Date: Jul 2008
Location: Influx.
Posts: 2,113
Rep Power: 20  |
Roller bearings for the stationary gears
Is there any reason why there hasn't been any productions of roller bearings for the stationary gears? It would seem to make sense to me to reduce friction even more by using low profile roller bearings on these locations, but then again I know nothing of the forces or loads those bearings see.
Maybe a ceramic ball bearing to support the eccentric shaft? Good idea? Bad Idea? Reasons why?
__________________
The Official FC Radiator Thread My Project Thread: Cerberus CCVT Virginia Rotary Group |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode