Any circuit board techs out there? I Need help

dudemaaan · 05-29-2008, 09:50 AM

My profect e-o1 stopped working after i relocated the display. I took the display apart to reroute the wires. It has 2 connectors with 6 wires and i think i may have reversed them. I tried the connectors both ways and still doesnt work. I really don't know why the connectors were identical but none the less its not working and greedy discontinued them and won't work on it. So i would like to send it somewhere for repair

And if anyone knows how i can get a schematic for the circuit board that would be very helpful. Thanks

scotty305 · 06-11-2008, 10:23 PM

I think your best bet would be to find someone else with an E-01 and ask them for photos of how it's supposed to go together. No point in fixing yours only to break it again by putting it back together wrong.

Finding a schematic would probably be impossible unless you know someone at Greddy. To fix it, try taking it to someone who's very good with R/C cars. Some of those guys are pretty skilled with electronics.

05-29-2008, 09:50 AM	#1
dudemaaan Rotary Fanatic Join Date: Mar 2008 Location: Brenham, TX iTrader: (4) Posts: 335 Rep Power: 17	Any circuit board techs out there? I Need help My profect e-o1 stopped working after i relocated the display. I took the display apart to reroute the wires. It has 2 connectors with 6 wires and i think i may have reversed them. I tried the connectors both ways and still doesnt work. I really don't know why the connectors were identical but none the less its not working and greedy discontinued them and won't work on it. So i would like to send it somewhere for repair And if anyone knows how i can get a schematic for the circuit board that would be very helpful. Thanks __________________ 500+ HP thanks to: Fast reacting IAT sensor thread! Mechanical Pre-turbo Water Injection Thread Dual Stock fuel pumps Thread T2 differential swap!

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

06-11-2008, 10:23 PM	#2
scotty305 Rotary Fan in Training Join Date: Mar 2008 Location: Culver City, CA iTrader: (0) Posts: 84 Rep Power: 17	I think your best bet would be to find someone else with an E-01 and ask them for photos of how it's supposed to go together. No point in fixing yours only to break it again by putting it back together wrong. Finding a schematic would probably be impossible unless you know someone at Greddy. To fix it, try taking it to someone who's very good with R/C cars. Some of those guys are pretty skilled with electronics.