Go Back   Rotary Car Club > Tech Discussion > RX-8 (2004 - Present)

RX-8 (2004 - Present) All things to do with RX-8

Reply
 
Thread Tools Display Modes
Old 03-11-2015, 05:42 PM   #1
fullsmoke
Where's the next apex?
 
Join Date: Jun 2008
Location: Atlanta, GA
iTrader: (0)
Posts: 13
Rep Power: 0
fullsmoke is on a distinguished road
Default Direction dependent vibration issue...

I have been having a weird vibration issues for the past few months. I can't tell if it has been getting worse. The vibration happens when traveling 50+mph (especially 60-70mph). The vibration is more noticeable when turning the steering wheel left (vibration becomes severe and whole car rattles). However, turning the wheel right makes the vibration go away completely (incredibly smooth like how the car should drive).

I don't have a reason to believe my alignment is off--tire wear seems to be OK. I've also visually inspected my suspension parts and cannot find anything broken or loose. The wheel bearings seem ok on the "wiggle the tire" test. There has never been any odd sounds (like metal clanking or grinding), only the vibration. I have rotated (back to front) and cross-rotated (left to right) my wheels yet there is no change in the vibration and direction.

Any advice on what to try next?

Thanks,
FS






__________________
I don't get mad. I wait for you to apex early.
fullsmoke is offline   Reply With Quote
Old 03-11-2015, 06:39 PM   #2
chibikougan
⊙⊙
 
chibikougan's Avatar
 
Join Date: Dec 2009
Location: Great Falls
iTrader: (4)
Posts: 1,258
Rep Power: 16
chibikougan will become famous soon enough
Default

Check your Halfshafts on the rearend Jack it up and have a good look around. Pay close attention to the inner CV near the Diff


Also look over the Driveline make sure all bolts are there and if the balance weights are still on it.
__________________
Quote:
You are not a beautiful and unique snowflake.
You are the same decaying organic matter as everyone else,
and we are all a part of the same compost pile.

Last edited by chibikougan; 03-11-2015 at 06:42 PM..
chibikougan is offline   Reply With Quote
Old 03-12-2015, 09:20 AM   #3
fullsmoke
Where's the next apex?
 
Join Date: Jun 2008
Location: Atlanta, GA
iTrader: (0)
Posts: 13
Rep Power: 0
fullsmoke is on a distinguished road
Default

Quote:
Originally Posted by chibikougan View Post
Check your Halfshafts on the rearend Jack it up and have a good look around. Pay close attention to the inner CV near the Diff


Also look over the Driveline make sure all bolts are there and if the balance weights are still on it.
The half shafts and their boots look solid. We don't have CV joints, correct? I didn't check the drive shaft yet...

FS
__________________
I don't get mad. I wait for you to apex early.
fullsmoke is offline   Reply With Quote
Old 03-12-2015, 11:00 AM   #4
FerociousP
I-had-a-bad-experience...
 
FerociousP's Avatar
 
Join Date: Feb 2008
Location: M'boro
iTrader: (2)
Posts: 1,046
Rep Power: 18
FerociousP is on a distinguished road
Default

Quote:
Originally Posted by fullsmoke View Post
The half shafts and their boots look solid. We don't have CV joints, correct? I didn't check the drive shaft yet...

FS
The rear axles are CV joints, jsut like a FWD car.

What it sounds like is something on the right side of the car. Turning left you are putting weight on that side, and causes more strain. Turning right you are shifting weight away, and lessens load on that side.

^the above is a pretty typical indication of a wheel bearing, rear axle, or even a tire with a broken belt. (ie. Something that is moving/rotating)

I once had an issue where the whole car would rythmically vibrate at highway speed, but couldn't pin it. I thought it was a wheel bearing. Turned out i let someone else driv ethe car while I followed, and the rear tire was moving around pretty violently. It just reached a strange resonance at that speed. Replaced the two rear tires, no more vibration. My point is, it can be something odd that you never expect.
__________________

'15 Juke Nismo
'06 MX-5 GT SOLD
'04 S Silver RX-8 GT Track Day Use SOLD
'90 Black TII vert w/ Sprint RE stock port/turbo DD dyno (242.6whp@5500rpm @12psi 8psi@redline) and (250ftlbtq@4800rpm @13psi) SOLD
'89 GTUs 6p TII SOLD, '87 sport SOLD, '79 SA stock SOLD
'91 B2600i 4x4 w/ Rx-8 LSD SOLD
FerociousP is offline   Reply With Quote
Old 03-25-2015, 10:30 AM   #5
fullsmoke
Where's the next apex?
 
Join Date: Jun 2008
Location: Atlanta, GA
iTrader: (0)
Posts: 13
Rep Power: 0
fullsmoke is on a distinguished road
Default

Thanks. I plan to replace my wheel bearings. How difficult is it to do? Do I need to buy the whole hub assembly or is it cheaper to just buy bearings and have a shop press them for me? (I don't have many specialized tools with me)

Thanks,
FS
__________________
I don't get mad. I wait for you to apex early.
fullsmoke is offline   Reply With Quote
Old 03-25-2015, 03:02 PM   #6
chibikougan
⊙⊙
 
chibikougan's Avatar
 
Join Date: Dec 2009
Location: Great Falls
iTrader: (4)
Posts: 1,258
Rep Power: 16
chibikougan will become famous soon enough
Default

http://foxed.ca/index.php?page=rx7manual


That covers everything..
__________________
Quote:
You are not a beautiful and unique snowflake.
You are the same decaying organic matter as everyone else,
and we are all a part of the same compost pile.
chibikougan is offline   Reply With Quote
Reply

Bookmarks

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump


All times are GMT -5. The time now is 09:05 PM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Hosted by www.GotPlacement.com
Ad Management by RedTyger