2004 PT71mm Rx8

ssspeedfreak · 02-05-2014, 06:36 AM

Hello, i have to telly you my journey with my Mazda Rx 8 started down the modification route almost as soon as i got it! I have learned do much and was inspired to build my garage suited to work on my add i learned no one cares more about your car than you!

Precision 71mm turbo with a Microtech, snow methanol stage three, titanium exhaust, 3"intake hard line and just about everything has been touched on this car.

I'm currently doing more modifications during the winter getting ready for a dyno tune then a super slick paint job to have it ready for summer.

85rx-7gsl-se · 02-05-2014, 07:44 AM

Still running the Renesis?

ssspeedfreak · 02-06-2014, 06:04 PM

Still a Renny, i hope to keep the Rx8 an Rx8! Just with more power.

Fendamonky · 02-06-2014, 06:11 PM

How are you planning on working around those exhaust port sizes?

ssspeedfreak · 02-12-2014, 08:30 PM

I'm bridge ported and I've touch the exhaust ports also. The engine design is how it is can't redesign it. Still this is the highest N/A rotory engine, good starting block. The rotors i had EDM'd to full FD height as the stock height and apex seals aren't enough.

02-05-2014, 06:36 AM	#1
ssspeedfreak The Newbie Join Date: Sep 2013 iTrader: (0) Posts: 3 Rep Power: 0	2004 PT71mm Rx8 Hello, i have to telly you my journey with my Mazda Rx 8 started down the modification route almost as soon as i got it! I have learned do much and was inspired to build my garage suited to work on my add i learned no one cares more about your car than you! Precision 71mm turbo with a Microtech, snow methanol stage three, titanium exhaust, 3"intake hard line and just about everything has been touched on this car. I'm currently doing more modifications during the winter getting ready for a dyno tune then a super slick paint job to have it ready for summer.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

02-06-2014, 06:04 PM	#3
ssspeedfreak The Newbie Join Date: Sep 2013 iTrader: (0) Posts: 3 Rep Power: 0	Still a Renny, i hope to keep the Rx8 an Rx8! Just with more power.

02-12-2014, 08:30 PM	#5
ssspeedfreak The Newbie Join Date: Sep 2013 iTrader: (0) Posts: 3 Rep Power: 0	I'm bridge ported and I've touch the exhaust ports also. The engine design is how it is can't redesign it. Still this is the highest N/A rotory engine, good starting block. The rotors i had EDM'd to full FD height as the stock height and apex seals aren't enough.