Degree wheel for port timing

sen2two · 11-05-2010, 08:32 PM

I have never had to use on of these before. I just used a rotor I machined out a slot in to create my porting. But i am doing a PP motor right now and would like to place the peripheral hole correctly by measuring the port timing.

I have read a few things here and there on how to use them, but everything I find is pretty vague or so over explained i get lost. Anyone want to make a short how-to video on using a degree wheel and post it up?

rxspeed7 · 11-05-2010, 09:14 PM

i can show you tomm when i come to pick up the manifold

rxspeed7 · 11-05-2010, 09:19 PM

I would also strongly suggest you read some of Lynn.E Hannover's posts on nopistons.com about the proper port timing procurement methods.

Zack.

11-05-2010, 08:32 PM	#1
sen2two KTEC Join Date: Jan 2009 iTrader: (2) Posts: 642 Rep Power: 0	Degree wheel for port timing I have never had to use on of these before. I just used a rotor I machined out a slot in to create my porting. But i am doing a PP motor right now and would like to place the peripheral hole correctly by measuring the port timing. I have read a few things here and there on how to use them, but everything I find is pretty vague or so over explained i get lost. Anyone want to make a short how-to video on using a degree wheel and post it up? __________________ what I have: 1985 Gs:12a All motor Drag car - 1973 Rx2: Play car What I had: 93 Touring: TRADED - 91 Coupe: TRADED - 90 GTU: RHD - 88 10AE: SOLD - 87 Base: SOLD - 86 Base: SOLD - 1985 GSLSE - 85 Gsl: SOLD - 80 Gs: TRADED - 1972 Rx2

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode