|
Show your rotary car build up. Show off your Rotary Car build! |
![]() |
|
Thread Tools | Display Modes |
![]() |
#16 | |
Mod With The Least :P
Join Date: Feb 2008
Location: Manchester, TN
Posts: 1,649
Rep Power: 0 ![]() |
Haha Estevan. Mine isn't nearly as badass as yours, but it should run ok
![]()
__________________
Resident Post Whore Polluting the environment one revolution at a time. ![]() www.tennspeed.net Quote:
|
|
![]() |
![]() |
![]() |
#17 |
counting down till DGRR
Join Date: Mar 2008
Location: Melbourne, Fl
Posts: 358
Rep Power: 18 ![]() |
![]() .
__________________
-74 RX-4 -84 REW GSL-SE Past rides -05 REW Swapped RX-8 -93 FD base |
![]() |
![]() |
![]() |
#18 | |
Mod With The Least :P
Join Date: Feb 2008
Location: Manchester, TN
Posts: 1,649
Rep Power: 0 ![]() |
Sounds good man.
__________________
Resident Post Whore Polluting the environment one revolution at a time. ![]() www.tennspeed.net Quote:
|
|
![]() |
![]() |
![]() |
#19 |
RCC Loves Me Not You
Join Date: Mar 2008
Location: Eagleville, TN
Posts: 2,267
Rep Power: 20 ![]() |
Very Nice!
__________________
1993 Yamaha GTS1000 1992 Celica Turbo AllTrac 1987 RX7 Sport 1979 Yamaha G1, KM24 powered 1975 Dolmar KMS4 |
![]() |
![]() |
![]() |
#20 | |
Mod With The Least :P
Join Date: Feb 2008
Location: Manchester, TN
Posts: 1,649
Rep Power: 0 ![]() |
Thanks Zach.
__________________
Resident Post Whore Polluting the environment one revolution at a time. ![]() www.tennspeed.net Quote:
|
|
![]() |
![]() |
![]() |
#21 | |
Mod With The Least :P
Join Date: Feb 2008
Location: Manchester, TN
Posts: 1,649
Rep Power: 0 ![]() |
Figured I would share an exhaust clip...
__________________
Resident Post Whore Polluting the environment one revolution at a time. ![]() www.tennspeed.net Quote:
|
|
![]() |
![]() |
![]() |
#22 |
Rotary Fanatic
Join Date: Feb 2008
Location: Front Royal, VA
Posts: 487
Rep Power: 18 ![]() |
Didn't sound bad. Have any luck with the intake issue yet?
|
![]() |
![]() |
![]() |
#23 | |
Mod With The Least :P
Join Date: Feb 2008
Location: Manchester, TN
Posts: 1,649
Rep Power: 0 ![]() |
Its been cold and wet here in STL so no go so far. Should have new plugs/wires/coil next week so that is when the real fun begins. Will probably ghetto compression check it too while I am at it.
__________________
Resident Post Whore Polluting the environment one revolution at a time. ![]() www.tennspeed.net Quote:
|
|
![]() |
![]() |
![]() |
#24 |
Rotary Fanatic
Join Date: Feb 2008
Location: Front Royal, VA
Posts: 487
Rep Power: 18 ![]() |
Considering thats the Mazda standard of motor replacement. Change the plugs/coils. If that clears up the issue then all good. If not replace motor.
|
![]() |
![]() |
![]() |
#25 | |
Mod With The Least :P
Join Date: Feb 2008
Location: Manchester, TN
Posts: 1,649
Rep Power: 0 ![]() |
Haha yeah. I have a forum member lined up for a rebuild if thats the case. I still have a hard time believing its low compression considering how easy it starts and how well it drove. My past rx7 experience said low compression = PITA to start.
__________________
Resident Post Whore Polluting the environment one revolution at a time. ![]() www.tennspeed.net Quote:
|
|
![]() |
![]() |
![]() |
#26 |
Rotary Fanatic
Join Date: Feb 2008
Location: Front Royal, VA
Posts: 487
Rep Power: 18 ![]() |
For some reason the Reni doesn't play like other rotaries. Usually hot start is the sure fire kicker. Getting the uprated starter, changing the plugs and coils like underwear, and running any oil other than 5w30 is the key to keeping them playing nice.
But your right normally hard starting sluggish throttle and hunting idle are the normal death notes. |
![]() |
![]() |
![]() |
#27 | |
Mod With The Least :P
Join Date: Feb 2008
Location: Manchester, TN
Posts: 1,649
Rep Power: 0 ![]() |
Well nowhere near a definitive test, but I let this car idle the other day for about 15-20 minutes. Then I shut it off, waited 5 minutes, and cranked her back up. Started almost as easy as initial startup. Previous owner stated Mazda two different times told him low compression and wanted $6k for a new motor since the mods voided the engine warranty.
__________________
Resident Post Whore Polluting the environment one revolution at a time. ![]() www.tennspeed.net Quote:
|
|
![]() |
![]() |
![]() |
#28 |
Rotary Fanatic
Join Date: Feb 2008
Location: Front Royal, VA
Posts: 487
Rep Power: 18 ![]() |
Man what did he do to it?
|
![]() |
![]() |
![]() |
#29 | |
Mod With The Least :P
Join Date: Feb 2008
Location: Manchester, TN
Posts: 1,649
Rep Power: 0 ![]() |
![]()
__________________
Resident Post Whore Polluting the environment one revolution at a time. ![]() www.tennspeed.net Quote:
|
|
![]() |
![]() |
![]() |
#30 |
Rotary Fanatic
Join Date: Feb 2008
Location: Front Royal, VA
Posts: 487
Rep Power: 18 ![]() |
No wonder it is blown! Reni's don't like turbos.
|
![]() |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|