window problems

speedjunkie · 07-24-2009, 08:14 AM

REVIT93RX7, you are correct!!

I pulled the fenders off and checked the connections. I started with the passenger side, not sure why haha, but it was connected fully. The rubber boots were pulled off though so I put those back on. Then I pulled the driver's fender and it wouldn't connect all the way. There are two added wires going through the top of the connector, I assume for an alarm that used to be in there, and when the jackasses at the shop put it back in, they didn't pull those wires tight from the inside while plugging it in, so the wires bunched up and made contact with the other pins and wouldn't allow it to connect all the way.

So there you have it.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

07-24-2009, 08:14 AM	#6
speedjunkie RCC Loves Me Not You Join Date: Mar 2008 Location: Colorado Springs, CO Posts: 2,089 Rep Power: 20	REVIT93RX7, you are correct!! I pulled the fenders off and checked the connections. I started with the passenger side, not sure why haha, but it was connected fully. The rubber boots were pulled off though so I put those back on. Then I pulled the driver's fender and it wouldn't connect all the way. There are two added wires going through the top of the connector, I assume for an alarm that used to be in there, and when the jackasses at the shop put it back in, they didn't pull those wires tight from the inside while plugging it in, so the wires bunched up and made contact with the other pins and wouldn't allow it to connect all the way. So there you have it.