FS: AZ haltech e8 w extras, gm coils, hx40 turbo, 321 stainless

fc steve · 06-07-2009, 05:31 PM

Selling my turbo and engine management setup.

Haltech e8 w terminated harness (was in fc) has sensors 3 bar map and boost control solenoid ~ $980 shipped

Gm d585 coils (these are the higher output ls2 truck coils w heatsinks on them) ~ $80 shipped

Holset hx40 turbo. Rebuilt w 1000 miles on my buddies dodge truck. comes with 19 cm wastegated hotside and 18 cm non wastegated housing ~ $340 shipped

321 stainless mandrel bends, (3) 180's and (2) 22.5*s on one piece ~ $95 shipped

jtbshaw · 06-07-2009, 05:48 PM

You should post the Holset on the Cummins forum. It will probably sell within the first day.

Also, what diameter tubing are the 321 bends...and wall thickness?

fc steve · 06-07-2009, 05:51 PM

3 and 3/4 clr 2 inch diameters .049 wall. the 22.5s are smaller 1 and 3/4 i believe (for 38mm gates)

fc steve · 07-05-2009, 03:43 PM

350 shipped for harness sensors ebc solenoid and gm coils

06-07-2009, 05:31 PM	#1
fc steve Rotary Fan in Training Join Date: Feb 2008 Posts: 40 Rep Power: 0	FS: AZ haltech e8 w extras, gm coils, hx40 turbo, 321 stainless Selling my turbo and engine management setup. Haltech e8 w terminated harness (was in fc) has sensors 3 bar map and boost control solenoid ~ $980 shipped Gm d585 coils (these are the higher output ls2 truck coils w heatsinks on them) ~ $80 shipped Holset hx40 turbo. Rebuilt w 1000 miles on my buddies dodge truck. comes with 19 cm wastegated hotside and 18 cm non wastegated housing ~ $340 shipped 321 stainless mandrel bends, (3) 180's and (2) 22.5*s on one piece ~ $95 shipped

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

06-07-2009, 05:48 PM	#2
jtbshaw ORD - Old Rotary Dude Join Date: Feb 2008 Location: Pelham, AL Posts: 319 Rep Power: 18	You should post the Holset on the Cummins forum. It will probably sell within the first day. Also, what diameter tubing are the 321 bends...and wall thickness?

06-07-2009, 05:51 PM	#3
fc steve Rotary Fan in Training Join Date: Feb 2008 Posts: 40 Rep Power: 0	3 and 3/4 clr 2 inch diameters .049 wall. the 22.5s are smaller 1 and 3/4 i believe (for 38mm gates)

07-05-2009, 03:43 PM	#4
fc steve Rotary Fan in Training Join Date: Feb 2008 Posts: 40 Rep Power: 0	350 shipped for harness sensors ebc solenoid and gm coils