|
|||||||
| RX-7 2nd Gen Specific (1986-92) RX-7 1986-92 Discussion including performance modifications and technical support sections. |
| View Poll Results: Which seals to replace | |||
| Replace the one stuck seal and the two corner seals |
   
|
1 | 33.33% |
| All new side and corner seals |
  
|
0 | 0% |
| All new side, corner, and RA seals |
  
|
2 | 66.67% |
| Voters: 3. You may not vote on this poll | |||
|
|
Thread Tools | Display Modes |
05-19-2009, 02:42 PM
|
#3 |
|
Rotary since 1972
Join Date: Nov 2008
Location: Tucson
Posts: 231
Rep Power: 17  |
If it has run that long and it did overheat I wouldn't suggest trying replace just the rear seals. Too much of a chance of something going wrong with other housing seals.
Tear it all down and spec everything. Especially rotor or rotor housing distortion. If all clearences are good on seals and rotors use them. You may find that one side seal is too long causing it to stick. Or there is a foreign object stuck somewhere. |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode