Differences between side draft manifolds?

TheDriver216 · 02-19-2009, 07:43 AM

you rent the dyno we can compare lol ... but then again i have 40mm chokes in my carb. which on a shorty side draft might be too much and lose alot more low end than if i were to have in 38's or even 36's.(which i left that set of 38's at your old shop hoepfully they didnt get tossed) Plus my carb is tuned via smell and plugs which i can be completely wrong about, but it doesnt smell as bad as when i first got it installed. but right now after 4k rpm it rips pretty good.

02-19-2009, 07:43 AM	#4
TheDriver216 Rotary Fanatic Join Date: Feb 2008 Location: Cleveland, Ohio Posts: 159 Rep Power: 18	you rent the dyno we can compare lol ... but then again i have 40mm chokes in my carb. which on a shorty side draft might be too much and lose alot more low end than if i were to have in 38's or even 36's.(which i left that set of 38's at your old shop hoepfully they didnt get tossed) Plus my carb is tuned via smell and plugs which i can be completely wrong about, but it doesnt smell as bad as when i first got it installed. but right now after 4k rpm it rips pretty good. Last edited by TheDriver216; 02-19-2009 at 07:47 AM.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode