flooding out FC3S4 N/A

Shadow24v · 02-13-2009, 02:14 PM

any particular reason you think the compression numbers are lower than he says? (hes a long-time member of a forum im on and a standup guy by general consensus) FWIW the injectors i sent came out of a running N/A so...*shrug*

on the subject of rebuilds, is there a quick and dirty rebuild to get the compression up to where it should be? im not liking the $900 pricetag for a master kit... aside from seals etc, can you do just the seals and such and have a refreshed motor?

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

02-13-2009, 02:14 PM	#11
Shadow24v Rotary Fan in Training Join Date: Feb 2009 Posts: 69 Rep Power: 17	any particular reason you think the compression numbers are lower than he says? (hes a long-time member of a forum im on and a standup guy by general consensus) FWIW the injectors i sent came out of a running N/A so...shrug on the subject of rebuilds, is there a quick and dirty rebuild to get the compression up to where it should be? im not liking the $900 pricetag for a master kit... aside from seals etc, can you do just the seals and such and have a refreshed motor?