New Coil Relocation Bracket - Feeler

Garfinkles Motor Works · 01-14-2009, 09:04 PM

The master plate is made for the plate using the 2nd gen leading coil and the drilling jig is made .The master plate is made for the plate with all stock coils but the drilling jig is NOT made as of today . I will make the jig as soon as I can get the time .The plate with the sec gen coil has 10 theaded holes and four spacers ,the stock coil plate has 9 threaded holes and no spacers .Both plates have matching mounting holes ( 4) so the plates will interchange if needed . The plate for the sec gen coil is a small bit longer .If I made one plate that mounted both types of coils then there will need to be 13 threaded holes ,that will drive the cost up so that will not be considered . Plus the spacers .

01-14-2009, 09:04 PM	#11
Garfinkles Motor Works RCC Contributor Join Date: Mar 2008 Posts: 535 Rep Power: 18	The master plate is made for the plate using the 2nd gen leading coil and the drilling jig is made .The master plate is made for the plate with all stock coils but the drilling jig is NOT made as of today . I will make the jig as soon as I can get the time .The plate with the sec gen coil has 10 theaded holes and four spacers ,the stock coil plate has 9 threaded holes and no spacers .Both plates have matching mounting holes ( 4) so the plates will interchange if needed . The plate for the sec gen coil is a small bit longer .If I made one plate that mounted both types of coils then there will need to be 13 threaded holes ,that will drive the cost up so that will not be considered . Plus the spacers . Last edited by Garfinkles Motor Works; 01-14-2009 at 09:06 PM. Reason: spelling

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode