TECH: Power steering conversion and A/C Removal

railgun · 03-07-2008, 10:32 PM

Pics would really drive home the point of the rack shaft. I'd call it more of a seal than a bearing since it's really sealing the inside of the rack from the outside.

I did this a couple years ago myself as well and it was very easy and I don't regret doing it for a sec. Low speed manuvering is MUCH better than just looping the lines. Still not as easy as w/ PS, but nice nonetheless.

Nice writeup.

03-07-2008, 10:32 PM	#4
railgun Rotolicious Join Date: Feb 2008 Location: ORD-LHR Posts: 60 Rep Power: 18	Pics would really drive home the point of the rack shaft. I'd call it more of a seal than a bearing since it's really sealing the inside of the rack from the outside. I did this a couple years ago myself as well and it was very easy and I don't regret doing it for a sec. Low speed manuvering is MUCH better than just looping the lines. Still not as easy as w/ PS, but nice nonetheless. Nice writeup. __________________ Rc³

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode