|
Show your rotary car build up. Show off your Rotary Car build! |
|
Thread Tools | Display Modes |
![]() |
#11 |
RCC Addict
Join Date: Feb 2008
Location: VA
Posts: 1,812
Rep Power: 19 ![]() |
September 8th, 2008 - New front fenders arrive
Low and behold, arrived home today from work and the new fenders are here. SA - Foresight +30mm. Stock "looking" but give the car the needed width to fit the bigger meats up front this car will need when I'm done w/ it. Also, the arch is cut 20 degrees lower as well for a little extra style and coverage. They weigh 3.8 pounds too! Before I actually install them, I'm going to POR15 and clean the fender areas, get new hardware and paint the door jam area, etc. For now, here's some shots. Its been since November 2005 that this car has had fenders, so it was a big step in the right direction for me ![]() Last edited by WE3RX7; 09-08-2008 at 06:40 PM. |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|