Rear Wheel Bearing Replacement

***ZGN*** · 02-23-2008, 04:11 PM

OK I was wrong, I am not able to get the Axle nut off. I have hit it with the impact with no luck I have taken a 24" breaker bar with no luck. I have blowtorched and lubed it up with wd40 then jumped up and down on the breaker bar with no luck. If 200lbs of me jumping on the bar does nothing then what can I do. Other then just keep taping away on all sides of the nut and lubing it heating it and trying to break it again.

If this does not work guess I'll have to try to cut it off without damaging the spindle.

Anyone?

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

02-23-2008, 04:11 PM	#2
*ZGN* Administrator Join Date: Jan 2008 Location: Birmingham, AL Posts: 2,264 Rep Power: 10	OK I was wrong, I am not able to get the Axle nut off. I have hit it with the impact with no luck I have taken a 24" breaker bar with no luck. I have blowtorched and lubed it up with wd40 then jumped up and down on the breaker bar with no luck. If 200lbs of me jumping on the bar does nothing then what can I do. Other then just keep taping away on all sides of the nut and lubing it heating it and trying to break it again. If this does not work guess I'll have to try to cut it off without damaging the spindle. Anyone?