SA cargo cover

[t_g_farrell]

Heres the plastic being cut for the wings



Inserting the plastic in the wings



And sealing up the slits



Next I took a look at the rear hatch attachment hooks and elastic bands.
Each wing has an imbedded aluminium tube that had a long elastic cord that ran
the length of the tube imbedded in the wing. These were fastened by being sewn
into the back edgd of the wing as part of the assembly. Mr. Murphy struck and
made these old elastic cords break loose. So I pulled the tubes out and cut the
cords to a short length of good cord. I then crimped a loop on one end and
inserted it into the tube and achored it with a screw run through the width of the
tube. I then reinserted the tubes into the wings and replaced the 3 hooks with
new stainless steel (this is the center hook):



Ok, cleaned both sides and painted bottom of cover, replaced snaps, restored
wing reinforcment, restored attaching cords and hooks. All thats left is
installation.