|
|||||||
| Show your rotary car build up. Show off your Rotary Car build! |
|
|
Thread Tools | Display Modes |
|
|||||||
| Show your rotary car build up. Show off your Rotary Car build! |
|
|
Thread Tools | Display Modes |
03-27-2015, 10:44 AM
|
#11 |
|
IT'S ALIVE!
Join Date: Dec 2009
Location: Richmond, VA
Posts: 811
Rep Power: 16  |
Update on my silly bolt-in roll bar ideas:
3/16" plates are welded to the main bulkhead on two faces. I think this is one of the strongest points on the car and is inches away from where the rear sub-frame bolts.  Closer views:   Yes, the plates are on an angle because I didn't like how the bar sat with them being flat. |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode