|
Show your rotary car build up. Show off your Rotary Car build! |
![]() |
|
Thread Tools | Display Modes |
|
![]() |
#1 |
VRR PSSH
Join Date: Apr 2009
Location: Sarasota, FL
Posts: 113
Rep Power: 17 ![]() |
Recharged the A/C yesterday using my Harbor Freight compressed-air-powered vacuum pump and A/C Manifold Gauge set.
I still had several bottles of ES-12a left over from the last time I charged my silver RX-7's A/C (that must have been like 4 years ago) and I had good results with that stuff so I used it again. The first thing I did was pull a vacuum on the system to check for leaks. I let it sit for over half an hour and found it held just fine (no leaks!) and then released the vacuum (since you're not supposed to charge with a vacuum when using ES-12a). I used about a can & 1/2 (and they are 6oz cans) to charge the system. At idle, this gave me about 45psi on the low side and 175 on the high side. The high side seems a little low, but that's expected when using this stuff, as I understand. Anyway it blows nice and cold now. Haven't done a temp test yet - just glad it's blowing cold air with FL summer heat coming... ![]() ![]() ![]() ![]() ![]()
__________________
1993 SSM, 20B (D449), SINGLE-TURBO, DIY-BUILD IN THE WORKS... |Build Thread| 1993 BB, 13B, SINGLE-TURBO, DAILY DRIVER |Build Thread| MY FACEBOOK PROFILE // BLACK LABEL ENGINEERING // ADVANCED RACE TECH // IR PERFORMANCE // THE BOOST LAB // [url=rotaryaddicts.com] |
![]() |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|