NA 6 port half bridge build (zenki FC)

Tougemonster · 07-27-2013, 05:45 PM

So it's I time to boost, motor is fully broken in.
Extra turbo LIM is ported for 6port
Trying to decide on a exhaust housing , I'm lookin at a To4b .60 a/r comp wheel with either a non divided .96 or a divided 1.12, any input?
Is a single 46mm waste gate enough to control boost a around 10-13 psi?
I'm going for a fast spooling, without limiting the top to much
Only want to rev to about 7800-8000

Getting a turbo parts car in a few days hopefully. Should make the transition to boost easier

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

07-27-2013, 05:45 PM	#33
Tougemonster Meat Popsicle Join Date: May 2010 Location: Missoula, MT Posts: 31 Rep Power: 0	So it's I time to boost, motor is fully broken in. Extra turbo LIM is ported for 6port Trying to decide on a exhaust housing , I'm lookin at a To4b .60 a/r comp wheel with either a non divided .96 or a divided 1.12, any input? Is a single 46mm waste gate enough to control boost a around 10-13 psi? I'm going for a fast spooling, without limiting the top to much Only want to rev to about 7800-8000 Getting a turbo parts car in a few days hopefully. Should make the transition to boost easier