Twin Charged FD - Fraternal Twins

JhnRX7 · 04-01-2013, 09:52 AM

What are those new calipers? Was that a custom job to make them wider for a larger disk? 32mm wide rotor? What Pads do you plan on running? Is that lettering a sticker or painted on? Looks like a cool setup. Any plans for the rear?

FYI. I had borrowed your idea of printing wiring labels on paper and using it under clear heat shrink. I used adhesive heat shrink for the wire connections, but not on the clear label heat shrink... Mistake. Oil leaked on one of the label areas and it got under the heat shrink and the paper sucked it right up. Rookie mistake. It looks like you did use the adhesive stuff for yours?

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

04-01-2013, 09:52 AM	#36
JhnRX7 Rotary Fanatic Join Date: Mar 2008 Posts: 142 Rep Power: 18	What are those new calipers? Was that a custom job to make them wider for a larger disk? 32mm wide rotor? What Pads do you plan on running? Is that lettering a sticker or painted on? Looks like a cool setup. Any plans for the rear? FYI. I had borrowed your idea of printing wiring labels on paper and using it under clear heat shrink. I used adhesive heat shrink for the wire connections, but not on the clear label heat shrink... Mistake. Oil leaked on one of the label areas and it got under the heat shrink and the paper sucked it right up. Rookie mistake. It looks like you did use the adhesive stuff for yours?