Harness Pics

C. Ludwig · 03-02-2011, 01:05 PM

We finally invested in a new label printer that prints on heat shrink. Allows us to make a better looking label than what we had been doing. This harness was built for a forum member for his FC. Sport 1000 harness setup for ID injectors, Hall effect crank trigger, and IGN-1A coils.

RXTASY · 01-22-2013, 04:54 PM

That looks purty!

Dannobre · 01-22-2013, 04:59 PM

Lot easier than printing them on little bits of paper and cutting them out

03-02-2011, 01:05 PM	#1
C. Ludwig Rotary Masochist Join Date: May 2008 Location: Floyds Knobs, IN iTrader: (5) Posts: 494 Rep Power: 17	Harness Pics We finally invested in a new label printer that prints on heat shrink. Allows us to make a better looking label than what we had been doing. This harness was built for a forum member for his FC. Sport 1000 harness setup for ID injectors, Hall effect crank trigger, and IGN-1A coils. __________________ _______________________________________________ *One stop Haltech, AEM, Syvecs shopping. Installation and tuning.* http://www.lms-efi.com *Free support. Drop us an email.* chris@lms-efi.com 502-515-7482 Facebook @LMS-EFI Last edited by C. Ludwig; 03-22-2011 at 05:53 PM..

01-22-2013, 04:54 PM	#2
RXTASY idahorotary.com Join Date: Mar 2010 Location: Idaho iTrader: (0) Posts: 135 Rep Power: 15	That looks purty! __________________ 87 TII-E85-600+ RWHP and climbing Life starts at 2 bar! Come visit my forum! idahorotary.com http://idahorotary.com/smf/index.php

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

01-22-2013, 04:59 PM	#3
Dannobre Rotary Fan in Training Join Date: Oct 2008 iTrader: (0) Posts: 87 Rep Power: 17	Lot easier than printing them on little bits of paper and cutting them out