Norwegian S4 Base TII

Pettersen · 01-20-2013, 04:41 AM

Took a pressure test of the coolant system, and turned out there was a leak, the front iron must have had a weakness in the coolant seal groove, cause it had broken loose while assembling the engine, very glad i found that now and not with the engine running.

So new Front iron on the way from UK.

While i wait i have taken care of some other small stuff.

Pfc is installed and the stock fc engine idles and drives ok with the base map, decided to test it on a engine and sensors i know work, so i can be shure that any problems with the semi pp engine, won't be related to the PFC hardware.

Built new exhaust from the header and back, used 2,25" SS pipe and v-bands, so it will be easy to take it down and modify later if nececary.

Have removed the old speaker shelf since i wasn't realy happy with how it looked, installed a new sub, should take about 10min to change out the sub for the rear tower strut.

Could clean up the wiring, but it's not realy a priority.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

01-20-2013, 04:41 AM	#26
Pettersen Rotary Fanatic Join Date: Mar 2010 Location: Norway Posts: 163 Rep Power: 16	Took a pressure test of the coolant system, and turned out there was a leak, the front iron must have had a weakness in the coolant seal groove, cause it had broken loose while assembling the engine, very glad i found that now and not with the engine running. So new Front iron on the way from UK. While i wait i have taken care of some other small stuff. Pfc is installed and the stock fc engine idles and drives ok with the base map, decided to test it on a engine and sensors i know work, so i can be shure that any problems with the semi pp engine, won't be related to the PFC hardware. Built new exhaust from the header and back, used 2,25" SS pipe and v-bands, so it will be easy to take it down and modify later if nececary. Have removed the old speaker shelf since i wasn't realy happy with how it looked, installed a new sub, should take about 10min to change out the sub for the rear tower strut. Could clean up the wiring, but it's not realy a priority.