|
|
|
||||||||
| Ludwig Motorsports www.ludwigmotorsports.com (IN/KY) Full service; rotary engine builds, swaps, fabrication, etc. |
 |
|
|
Thread Tools | Display Modes |
|
|
|
|
||||||||
| Ludwig Motorsports www.ludwigmotorsports.com (IN/KY) Full service; rotary engine builds, swaps, fabrication, etc. |
|
|
|
Thread Tools | Display Modes |
12-06-2012, 05:00 AM
|
#1 |
|
Rotary Masochist
|
Syvecs rotary cal file
For those looking to see what a Syvecs rotary map would look like.
http://www.lms-efi.com/lmsefi/syvecs/RX7_Base.SC
__________________
_______________________________________________ One stop Haltech, AEM, Syvecs shopping. Installation and tuning. http://www.lms-efi.com Free support. Drop us an email. chris@lms-efi.com 502-515-7482 Facebook @LMS-EFI |
|
|
|
12-06-2012, 05:09 AM
|
#2 |
|
Professional Stick Poker
|
Thanks for the file. I went to the Syvecs site and downloaded the software to view the file. That system is amazing, the only thing I haven't found a setting for was tea service.
__________________
1979 SA22C (parts of one anyway) http://rotarycarclub.com/rotary_foru...ad.php?t=15585 1975 MG Midget (building) http://rotarycarclub.com/rotary_foru...ad.php?t=18681 1988 N/A SE model FC, dead stock and less than 85k on the clock. This one actually runs, so I don't fuck with it. 
|
|
|
|
|
12-06-2012, 05:26 AM
|
#3 | |
|
Don Mega
|
Quote:
It has incorrect injector settings (4cyl) No ign settings Incorrect injector balance Has a few thermistor settings and other bits n pieces but its far from a running base map I strongly suggest before you get a customer to trail it on you set it up, if you want a hand Ludwig you can e-mail me and I will fix up the file for you to one that is actually use in a rotary, a running one.
__________________
www.riceracing.com.au Worlds best Apex Seals Coil on Plug Water Injection ECU Calibration |
|
|
|
|
Linear Mode
