Tegheim - Home made 4 rotor Wolvo 142

N.RotaryTech · 08-26-2012, 09:26 AM

Go with the side-port setup.

I hate it when ppl get there 3 or 4 rotor engine for the first time and port the shit out of it.
See what its like with stock ports first, and play around with boost. Then later down the road if you still desire to port it, do so.

I've been keeping an eye out on this thread.
So once again, I'll give you props on your building skills.
Inspirational.

My5ABaby · 08-29-2012, 04:52 PM

Quote:

Originally Posted by N.RotaryTech

I hate it when ppl get there 3 or 4 rotor engine for the first time and port the shit out of it.

Go big or go home.

08-26-2012, 09:26 AM	#1
N.RotaryTech Home-brew Rotary Join Date: Feb 2008 Location: GooseCreek SC Posts: 552 Rep Power: 18	Go with the side-port setup. I hate it when ppl get there 3 or 4 rotor engine for the first time and port the shit out of it. See what its like with stock ports first, and play around with boost. Then later down the road if you still desire to port it, do so. I've been keeping an eye out on this thread. So once again, I'll give you props on your building skills. Inspirational. __________________ '89 RX7 GTU, half-Bridge-port S4/S5 NA, E6K, Full RB exhaust, weekend warrior. '83 RX7, The "this might take awhile" project. '87 RX7 GXL, Rest In Pieces. '98 Subaru Impreza Outback-sport, rx7 rescue vehicle, down for repair. '94 Ford Ranger, daily.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode