Twin Charged FD - Fraternal Twins

RX SE7EN · 04-11-2012, 09:42 AM

Thanks John,

Unfortunately this week hasn't gone very well so far though. Everything seems to be taking forever. I'm taking tomorrow off of work, and working all weekend on it. That's 3 solid days to do the following:

Must do's:
Make the fuel lines
Make the brake lines
Make the coolant lines
Make the vacuum lines
Mount the wastegate solenoid
Mount the MAP sensor
Mount the EGT sensors and signal box
Relocate meth pump (duct work is now in the way)
Make one more oil cooler duct
Port all the piping (smooth out rough edges)
Add ICV to the plenum
Remove the dash, finish the new wire harness, install it, re-install the dash
Add oil
Add coolant
Get tuned (Monday night I hope)

Like to do's
Add brake ducts
Install BBK
Make A/C lines

I need to have a productive 3 days.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

04-11-2012, 09:42 AM	#11
RX SE7EN Rotary Fanatic Join Date: Feb 2010 Posts: 183 Rep Power: 16	Thanks John, Unfortunately this week hasn't gone very well so far though. Everything seems to be taking forever. I'm taking tomorrow off of work, and working all weekend on it. That's 3 solid days to do the following: Must do's: Make the fuel lines Make the brake lines Make the coolant lines Make the vacuum lines Mount the wastegate solenoid Mount the MAP sensor Mount the EGT sensors and signal box Relocate meth pump (duct work is now in the way) Make one more oil cooler duct Port all the piping (smooth out rough edges) Add ICV to the plenum Remove the dash, finish the new wire harness, install it, re-install the dash Add oil Add coolant Get tuned (Monday night I hope) Like to do's Add brake ducts Install BBK Make A/C lines I need to have a productive 3 days.