Couple Qs, Idle dipping & PCV location

FRED · 06-07-2011, 04:05 PM

PVC is located on the rear end of that line of solenoids on the left side of the engine. Its called the PURGE VALVE and is made of black plastic and is close to the oil filter area. One hose on its top and two on its bottom. Page F1-70 of the FSM shows it. Fuel and Emissions section.

The BAC seems to be working on your car........mabe........so check the DASHPOT on the throttle linkage for being functional. Its shown in the FUEL AND EMISSIONS section of the FSM also.

Then again it could be BAC related. Idle the engine fully hot and then pull the elect plug off the BAC. Usually the idle will drop a bit doing that. Just a hundred or so drop. Then again if the idle was set near 800 rpm then the drop probably will not show up.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

06-07-2011, 04:05 PM	#2
FRED Rotary Fan in Training Join Date: Mar 2011 Posts: 73 Rep Power: 15	PVC is located on the rear end of that line of solenoids on the left side of the engine. Its called the PURGE VALVE and is made of black plastic and is close to the oil filter area. One hose on its top and two on its bottom. Page F1-70 of the FSM shows it. Fuel and Emissions section. The BAC seems to be working on your car........mabe........so check the DASHPOT on the throttle linkage for being functional. Its shown in the FUEL AND EMISSIONS section of the FSM also. Then again it could be BAC related. Idle the engine fully hot and then pull the elect plug off the BAC. Usually the idle will drop a bit doing that. Just a hundred or so drop. Then again if the idle was set near 800 rpm then the drop probably will not show up.