|
|
|
||||||||
| Introduce yourself!! Tell me something about you and your history with rotary.. |
 |
|
|
Thread Tools | Display Modes |
|
|
|
|
||||||||
| Introduce yourself!! Tell me something about you and your history with rotary.. |
|
|
|
Thread Tools | Display Modes |
05-10-2011, 10:59 AM
|
#1 |
|
The Newbie
|
hey, from vale,nc
just picked up a 91 rx7 n/a while deployed and came back with money to spend. bought a few odds and ends: tein lowering springs, tanabe front strut bar, corksport radiator w/hks cap, corksport header back exhaust, mazdatrix short shifter with all new boots, 5zigen fn01rc 17x9rear/17x8front, ss clutch line....
in the middle of an omp block off project right now which is why i came here. hoping to learn how to get my engine back together ha. 
|
|
|
|
05-10-2011, 12:09 PM
|
#2 |
|
Waffles - hmmm good
|
Theres folks all around you with 7s. I'm across the lake in Huntersville, exit 25 on 77. Theres some folks up in statesville and in asheville. Theres also someone
in denver, a little closer to you and he has 2nd gen experience. Goes by the SN of BigIslandsSeven on here and the other board. Welcome back and thank you for your service.
__________________
1980 GS stockport, Fat Nikki, RB Dual Facetfuel pumps, Holley regulator, RB Street port exhaust, 2GDFIS, MR2 MK I electric fans, 2G strut bar, relayed fans, lights and fuel pump, LEDs Project Fat Nikki Budget 12A rebuild Video setup < $30.00 |
|
|
|
Linear Mode
