I need 5/32 Oil injection line

aaronoverholser · 03-23-2011, 11:05 PM

I want to replace the oil injection lines on my 13B engine. I understand that they are 5/32" ID, so I asked my local auto parts store with no luck. Does anyone know where to locate a length of this along with some clamps?

Thanks for the help!

RETed · 03-24-2011, 12:45 AM

These are typically replaced by pre-assembled parts from the Mazda dealer.
These oil injection hoses are pre-molded and follow a specific path.
It's very hard to get generic hose to do this.

-Ted

C. Ludwig · 03-24-2011, 01:04 AM

MSC Supply. Oil line and the clamps. As Ted said, it's hard to route them, but it can be done. A LOT less expensive than Mazda as well.

FRED · 03-27-2011, 10:16 AM

http://www.mcmaster.com/#52355k12/=bm6l7w

There's nothing difficult in doing this at all.

03-23-2011, 11:05 PM	#1
aaronoverholser In search of knowledge. Join Date: Mar 2011 Location: Greenville Ohio iTrader: (0) Posts: 14 Rep Power: 0	I need 5/32 Oil injection line I want to replace the oil injection lines on my 13B engine. I understand that they are 5/32" ID, so I asked my local auto parts store with no luck. Does anyone know where to locate a length of this along with some clamps? Thanks for the help! __________________ Zoom Zoom- The only car on the road that is truly something different... the RX7!

03-24-2011, 01:04 AM	#3
C. Ludwig Rotary Masochist Join Date: May 2008 Location: Floyds Knobs, IN iTrader: (5) Posts: 494 Rep Power: 17	MSC Supply. Oil line and the clamps. As Ted said, it's hard to route them, but it can be done. A LOT less expensive than Mazda as well. __________________ _______________________________________________ *One stop Haltech, AEM, Syvecs shopping. Installation and tuning.* http://www.lms-efi.com *Free support. Drop us an email.* chris@lms-efi.com 502-515-7482 Facebook @LMS-EFI

03-27-2011, 10:16 AM	#4
FRED Rotary Fan in Training Join Date: Mar 2011 iTrader: (0) Posts: 73 Rep Power: 14	http://www.mcmaster.com/#52355k12/=bm6l7w There's nothing difficult in doing this at all. Last edited by FRED; 03-27-2011 at 10:19 AM..

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode