Diary of a Madman; TitaniumTT's see you @ DGRRXI RE-REbuild

RX SE7EN · 03-16-2011, 08:25 AM

I'm not 100% sure, but I think PFS used to use a generic borla resonator in the midpipe (like mine is) when they did major upgrades (so supports wouldn't be a problem in this case). Not 100% sure though, I guess it could have been a customer request back when my car was built the first time by the previous owner. I've seen the borla on a couple other PFS cars, not sure if they still do it if they ever did.

My exhaust system is: 3" greddy T78 kit downpipe, midpipe with borla resonator (assuming a PFS standard), and HKS system back from there. I still wish it was a little more toned down. I've been thinking about trying to squeeze the largest magnaflow muffler that will fit in where the Borla is.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

03-16-2011, 08:25 AM	#10
RX SE7EN Rotary Fanatic Join Date: Feb 2010 Posts: 183 Rep Power: 16	I'm not 100% sure, but I think PFS used to use a generic borla resonator in the midpipe (like mine is) when they did major upgrades (so supports wouldn't be a problem in this case). Not 100% sure though, I guess it could have been a customer request back when my car was built the first time by the previous owner. I've seen the borla on a couple other PFS cars, not sure if they still do it if they ever did. My exhaust system is: 3" greddy T78 kit downpipe, midpipe with borla resonator (assuming a PFS standard), and HKS system back from there. I still wish it was a little more toned down. I've been thinking about trying to squeeze the largest magnaflow muffler that will fit in where the Borla is.