|
|||||||
| Fabrication Show off the parts that you've built from scratch or highly modified |
|
|
Thread Tools | Display Modes |
|
|||||||
| Fabrication Show off the parts that you've built from scratch or highly modified |
|
|
Thread Tools | Display Modes |
03-03-2011, 02:50 PM
|
#11 | |
|
⊙⊙
Join Date: Dec 2009
Location: Great Falls
Posts: 1,258
Rep Power: 17  |
I like what your doing there. If you mount the LEDs in plexi be sure to torch the edges and back so all the light is forced through the Face. Just Torch enough to fog it not melt it. It should light up your turn signal arrows you have pictured really nicely and all you have to do is cut a cube of plexi and mount it to the back of the cutout. Mount LED inside the cube and you are good to go. If you don't want to see the LED you can mount it to the bottom of the cube so that it is a little lower then the arrow cutout so it should just make for a nice bright clean arrow.
__________________
Quote:
Last edited by chibikougan; 03-03-2011 at 02:54 PM. |
|
|
|
| Bookmarks |
| Tags |
| dash, iq3, upholstery, vinyl wrapping |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode